User Guide

LM960 HW Design Guide
1VV0301485 Rev. 3 Page 64 of 74 2018-12-14
Antenna List
Note: The antenna connector is SMA(Male) type.
FCC Class B digital device notice
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
 Consult the dealer or an experienced radio/TV technician for help.
No. Manufacturer Part No. Antenna Type Peak Gain
1 HNS WE14-LF-07 Dipole
1.5 dBi for 617 ~ 960 MHz
3.5 dBi for 1420 ~ 2200 MHz
3 dBi for 2300 ~ 2690 MHz
2 HNS WE14-S3-1 Dipole
4 dBi for 1420 ~ 2200 MHz
1 dBi for 2300 ~ 2400 MHz
3 dBi for 2498 ~ 2690 MHz
3 dBi for 5150 ~ 5928 MHz
3 HNS WE14-S3-2 Dipole 1 dBi for CBRS(3550 ~ 3700 MHz)