User Guide

LM960 HW Design Guide
1VV0301485 Rev. 3 Page 53 of 74 2018-12-14
Information
This device is to be used only for mobile and fixed application. The
antenna(s) used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and must not be
co-located or operating in conjunction with any other antenna or
transmitter. End-Users must be provided with transmitter operation
conditions for satisfying RF exposure compliance. OEM integrators
must ensure that the end user has no manual instructions to remove
or install the LM960 module. Antennas used for this OEM module must
not exceed gain of below table for mobile and fixed operating
configurations.
In the event that these conditions cannot be met (for example certain
laptop configurations or co-location with another transmitter), then the
FCC/IC authorization is no longer considered valid and the FCC/IC ID
cannot be used on the final product. In these circumstances, the OEM
integrator will be responsible for re-evaluating the end product
(including the transmitter) and obtaining a separate FCC/IC
authorization.
Manual Information to the End User
The OEM integrator has to be aware not to provide information to the
end user regarding how to install or remove this RF module in the
user’s manual of the end product which integrates this module. The
end user manual shall include all required regulatory
information/warning as show in this manual.