User's Guide

LM940 HW Design Guide

1VV0301352 Rev. 2 Page 60 of 68 2017-07-19

FDD 1900+ – B25

FDD 850+ – B26

FDD 700 APT – B28

FDD 700d – B29

FDD 2300 WCS – B30

FDD AWS-3 – B66

TDD 2600 – B38

TDD 2300 – B40

TDD 2500 – B41

3.5

3.0

1.5

3.5

4.0

WCDMA 2100 – B1

1900 PCS – B2

1800 AWS-1 – B4

850 – B5

900 – B8

3.5

3.0

This transmitter must not be co-located or operating in conjunction with any other antenna

or transmitter.

L'émetteur ne doit pas être colocalisé ni fonctionner conjointement avec à autre antenne

ou autre émetteur.

FCC Class B digital device notice

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of the following measures:

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and receiver.

 Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.