User's Manual

LE920 Hardware User Guide

1vv0301026 Rev.0 - draft4 – 2013-05-

17. Document History

Revision Date Changes

0-draft1 2012-10-03 First issue

0-draft2 2012-12-11 - Remove SIM2 interface

- Remove external GPS LNA support

0-draft3 2013-03-12 Updated pin-out

0-draft4 2013-05-21 - Update DVI

- Adding Current consumption

- Adding SHDN_N section

- Update Mechanical drawings

FCC Warning

This equipment has been tested and found to comply with the limits for a class B digital device,

ursuant to part 15 of the FCC rules. These limits are designed to provide to provide reasonable

rotection against harmful interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used in accordance with the

installation, may cause harmful interference to radio communication. However, there is no guarantee

that interference

will not occur in a particular installation. if this equipment does cause harmful interference to radio

or television reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna

-Increase the separation between the equipment and receiver

-Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected

-Consult the dealer or an experienced radio / TV technician for help

You are cautioned that changes or modifications not expressly approved by the party responsible for

compliance could void your authority to operate the equipment.

This device complies with part 15 of the FCC rules. Operation is subject to the following two

conditions

(1) This device may not cause harmful interference and

(2) this device must accept any interference received, including interference that may cause undesired

operation.

“Contains FCC ID：RI7LE920NA

“Contains IC：5131A-LE920NA

Label：