User's Manual

L
LE920 Hardware User Guide
1vv0301026 Rev.0 - draft4 – 2013-05-
Reproduction forbidden without written authorization from Telit Communications S.p.A. - All Rights Reserved. Page 63 of 76
13.3.
Recommended foot print for the application
198 pads
Top View
In order to easily rework the LE920 it is suggested to consider on the application having a 1.5
mm placement inhibit area around the module.
It is also suggested, as a common rule for an SMT component, to avoid having a mechanical
part of the application in direct contact with the module.
NOTE:
In the customer application, the region under WIRING INHIBIT (see figure) must be clear
from signal or ground paths.