User's Manual

L
LE920 Hardware User Guide
1vv0301026 Rev.0 - draft4 – 2013-05-
Reproduction forbidden without written authorization from Telit Communications S.p.A. - All Rights Reserved. Page 59 of 76
11.4.
Using the Temperature Monitor Function
11.4.1.
Short Description
The Temperature Monitor is a function of the module that permits to control its internal
temperature and if properly set (see the #TEMPMON command on AT Interface guide) it
raises to High Logic level a GPIO when the maximum temperature is reached.
11.5.
Indication of Network Service Availability
The STAT_LED pin status shows information on the network service availability and call
status. In the LE920 modules, the STAT_LED usually needs an external transistor to drive an
external LED. Because of the above, the status indicated in the following table is reversed
with respect to the pin status:
LED status Device Status
Permanently off Device off
Fast blinking
(Period 1s, Ton 0,5s)
Net search / Not registered /
turning off
Slow blinking
(Period 3s, Ton 0,3s)
Registered full service
Permanently on a call is active