User's Manual

LE910 V2 HARDWARE USER GUIDE 1VV0301200 Rev.2 Preliminary • 2015-08-04 77 of 81
Reproduction forbidden without Telit Communications PLC written authorization – All Rights Reserved
Cet appareil est conforme aux limites d'exposition aux rayonnements de la IC pour un environnement non contrôlé.
L'antenne doit être installé de façon à garder une distance minimale de 20 centimètres entre la source de
rayonnements et votre corps. Gain de l'antenne doit être ci-dessous:
Gain de l‘antenne
Bande de fréquence
LE910-NA V2
LE910-SV V2
700 MHz
6.63 dBi
6.94 dBi
850 MHz
6.63 dBi
N/A
1700 MHz
6.00 dBi
6.00 dBi
1900 MHz
8.51 dBi
9.01 dBi
L'émetteur ne doit pas être colocalisé ni fonctionner conjointement avec à autre antenne ou autre émetteur.
FCC Class B digital device notice
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Labelling Requirements for the Host device
The host device shall be properly labelled to identify the modules within the host device. The certification label of
the module shall be clearly visible at all times when installed in the host device, otherwise the host device must be
labelled to display the FCC ID and IC of the module, preceded by the words "Contains transmitter module", or the
word "Contains", or similar wording expressing the same meaning, as follows:
LE910-NA V2
Contains FCC ID: RI7LE910NAV2
Contains IC: 5131A-LE910NAV2
LE910-SV V2
Contains FCC ID: RI7LE910SVV2
Contains IC: 5131A-LE910SVV2