User's Manual

LE910 V2 HARDWARE USER GUIDE 1VV0301200 Rev.2 Preliminary • 2015-08-04 66 of 81
Reproduction forbidden without Telit Communications PLC written authorization – All Rights Reserved
9 APPLICATION PCB
DESIGN
The LE910 V2 modules have been designed in order to be compliant with a standard lead-free SMT process.
9.1 Footprint
TOP VIEW
In order to easily rework the LE910 V2 is suggested to consider on the application a 1.5 mm placement inhibit area
around the module.
It is also suggested, as common rule for an SMT component, to avoid having a mechanical part of the application
in direct contact with the module.
NOTE:
In the customer application, the region under WIRING INHIBIT (see figure above) must
be clear from signal or ground paths.