User's Manual
LE910 V2 HARDWARE USER GUIDE 1VV0301200 Rev.2 Preliminary • 2015-08-04 29 of 81
Reproduction forbidden without Telit Communications PLC written authorization – All Rights Reserved
4.4 RTC Bypass out
The VRTC pin brings out the Real Time Clock supply, which is separate from the rest of the digital part, allowing
having only RTC going on when all the other parts of the device are off.
To this power output a backup capacitor can be added in order to increase the RTC autonomy during power off of
the battery. NO Devices must be powered from this pin.
In order to keep the RTC active when VBATT is not supplied it is possible to back up the RTC section connecting
a backup circuit to the related VRTC signal (pad C14 on module’s Pinout).
For additional details on the Backup solutions please refer to the related application note (xE910 RTC Backup
Application Note)
4.5 VAUX Power Output
A regulated power supply output is provided in order to supply small devices from the module. The signal is present
on Pad R11 and it is in common with the PWRMON (module powered ON indication) function.
This output is always active when the module is powered ON.
The operating range characteristics of the supply are:
Item
Min
Typical
Max
Output voltage
1.78V
1.80V
1.82V
Output current
-
-
60mA
Output bypass capacitor
(inside the module)
1uF