User's Guide

LE910 V2 HARDWARE USER GUIDE 1VV0301200 Rev.8 • 2016-10-07 80 of 84

This transmitter must not be co-located or operating in conjunction with any other

antenna or transmitter.

Cet appareil est conforme aux limites d'exposition aux rayonnements de l’ISED pour un environnement non

contrôlé. L'antenne doit être installé de façon à garder une distance minimale de 20 centimètres entre la source de

rayonnements et votre corps. Gain de l'antenne doit être ci-dessous:

Gain de l‘antenne

Bande de fréquence

LE910-NA V2

LE910-NA1

LE910-SV V2

LE910-SV1

LE910-SVL

700 MHz

6.63 dBi

6.94 dBi

6.95 dBi

850 MHz

6.63 dBi

N/A

1700 MHz

6.00 dBi

1900 MHz

8.51 dBi

9.01 dBi

N/A

L'émetteur ne doit pas être colocalisé ni fonctionner conjointement avec à autre antenne ou autre émetteur.

FCC Class B digital device notice

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15

of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of the following measures:

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and receiver.

 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

 Consult the dealer or an experienced radio/TV technician for help.

Labelling Requirements for the Host device

The host device shall be properly labelled to identify the modules within the host device. The certification label of

the module shall be clearly visible at all times when installed in the host device, otherwise the host device must be

labelled to display the FCC ID and ISED of the module, preceded by the words "Contains transmitter module", or

the word "Contains", or similar wording expressing the same meaning, as follows:

LE910-NA V2 and LE910-NA1

Contains FCC ID: RI7LE910NAV2

Contains IC: 5131A-LE910NAV2