User's Manual

LE910 Hardware User Guide

1vv0301089 Rev.7 – 25-10-2015

The conformity assessment procedure referred to in Article 10 and detailed in Annex IV of Directive

1999/5/EC has been followed with the involvement of the following Notified Body:

AT4 wireless, S.A.

Parque Tecnologico de Andalucía

C/ Severo Ochoa 2

29590 Campanillas – Málaga

SPAIN

Notified Body No: 1909

Thus, the following marking is included in the product:

The full declaration of conformity can be found on the following address:

http://www.telit.com/

There is no restriction for the commercialisation of the LE910-EUG modules in all the countries of the

European Union.

Final product integrating this module must be assessed against essential requirements of the 1999/5/EC

(R&TTE) Directive. It should be noted that assessment does not necessarily lead to testing. Telit

Communications S.p.A. recommends carrying out the following assessments:

RF spectrum use (R&TTE art. 3.2)

It will depend on the antenna used on the final product.

EMC (R&TTE art. 3.1b)

Testing

Health & Safety (R&TTE art. 3.1a)

Testing

Alternately, assessment of the final product against EMC (Art. 3.1b) and Electrical safety (Art. 3.1a)

essential requirements can be done against the essential requirements of the EMC and the LVD Directives:

 Low Voltage Directive 2006/95/EC and product safety

 Directive EMC 2004/108/EC for conformity for EMC

1909