User's Guide

LE910Cx HW User Guide
Doc#: 1VV0301298
Rev. 13.0 Page 44 of 124 2019-07-15
NOTE:
For systems not requiring controlled power ON/OFF, automatic power on can
be supported by shorting the ON_OFF signal directly GND
In this case, the module will start power on sequence immediately after
VBATT supply is applied
NOTE:
Active low signals are labeled with a name that ends with "#" or with “_N”
NOTE:
To avoid a back-powering effect, it is recommended to avoid having any
HIGH logic level signal applied to the digital pins of the module when it is
powered OFF or during an ON/OFF transition.