User's Guide

LE910Cx HW User Guide
Doc#: 1VV0301298
Rev. 13.0 Page 113 of 124 2019-07-15
Le présent appareil est conforme à l'exposition aux radiations FCC / ISED définies pour
un environnement non contrôlé et répond aux directives d'exposition de la fréquence de la
FCC radiofréquence (RF) et RSS‐102 de la fréquence radio (RF) ISED règles
d'exposition. Gain de l'antenne doit être ci-dessous:
Frequency
Band
Freq
[MHz]
LE910C1
-NA Gain
[dBi]
LE910C1
-NS Gain
[dBi]
LE910C1/C4
-NF Gain
[dBi]
LE910C1
-SV Gain
[dBi]
LE910C1
/C4 -LA
Gain
[dBi]
LE910C1
-SA Gain
[dBi]
LE910C1
-ST Gain
[dBi]
850 MHz
850
3.64
6.08
6.12
NA
3.5
NA
NA
1900 MHz
1900
2.51
8.01
8.01
NA
9.5
8.01
8.01
1700 MHz
1700
5.00
5.00
5.00
6.00
13.0
5.00
5.00
900 MHz
900
5.00
N/A
N/A
N/A
N/A
NA
NA
700 MHz
700
5.63
5.63
5.94
6.44
N/A
5.63
5.63
600 MHz
600
N/A
N/A
5.63
N/A
N/A
NA
5.63
2700 MHz
2700
N/A
N/A
N/A
N/A
13.0
NA
NA
L'émetteur ne doit pas être colocalisé ni fonctionner conjointement avec à autre antenne
ou autre émetteur.
FCC Class B Digital Device Notice
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Labelling Requirements for the Host device
The host device shall be properly labelled to identify the modules within the host device.
The certification label of the module shall be clearly visible at all times when installed in
the host device, otherwise the host device must be labelled to display the FCC ID and IC
of the module, preceded by the words "Contains transmitter module", or the word
"Contains", or similar wording expressing the same meaning, as follows: