User's Guide

LE910Cx HW User Guide
Doc#: 1VV0301298
Rev. 13.0 Page 111 of 124 2019-07-15
14. Conformity Assessment Issues
FCC/ISED Regulatory Notices
Information for the OEMs and Integrators
The following statement must be included with all versions of this document supplied to an
OEM or integrator but should not be distributed to the end user.
1) This device is intended for OEM integrators only.
2) Please see the full Grant of Equipment document for other restrictions
Manual Information To the End User
The OEM integrator has to be aware not to provide information to the end user regarding
how to install or remove this RF module in the user’s manual of the end product which
integrates this module. The end user manual shall include all required regulatory
information/warming as shown in this manual
Modular approval RF Exposure
This equipment must be installed and operated in accordance with provided instructions
and the antenna(s) used for this transmitter must be installed to provide a separation
distance of at least 20 cm from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter. End-users and installers must be
provide with antenna installation instructions and consider removing the no-collocation
statement
Information on test modes and additional testing requirement
The module has been evaluated in mobile stand-alone conditions. For different
operational conditions from a stand-alone modular transmitter in a host (multiple,
simultaneously transmitting modules or other transmitters in a host), additional testing
may be required (collocation, retesting…) If this module is intended for use in a portable
device, you are responsible for separate approval to satisfy the SAR requirements of FCC
Part 2.1093 and IC RSS-102
Additional testing, Part 15 Subpart B disclaimer
The modular transmitter is only FCC authorized for the specific rule parts (i.e., FCC
transmitter rules) listed on the grant, and that the host product manufacturer is responsible
for compliance to any other FCC rules that apply to the host not covered by the modular
transmitter grant of certification. If the grantee markets their product as being Part 15
Subpart B compliant (when it also contains unintentional-radiator digital circuity), then the
grantee shall provide a notice stating that the final host product still requires Part 15
Subpart B compliance testing with the modular transmitter installed. The end product with
an embedded module may also need to pass the FCC Part 15 unintentional emission
testing requirements and be properly authorized per FCC Part 15