User's Guide

LE866 HARDWARE USER GUIDE 1vv0301210 Rev.0 Preliminary 2015-09-02 54 of 68
Reproduction forbidden without Telit Communications PLC written authorization All Rights Reserved
9 APPLICATION DESIGN
The LE866 modules have been designed in order to be compliant with a standard lead-free SMT
process.
Footprint
TBD
In order to easily rework the LE866 is suggested to consider on the application a 1.5 mm placement
inhibit area around the module.
It is also suggested, as common rule for an SMT component, to avoid having a mechanical part of the
application in direct contact with the module.
NOTE:
In the customer application, the region under WIRING INHIBIT (see figure
above) must be clear from signal or ground paths.