User's Guide
LE866 HARDWARE USER GUIDE 1vv0301210 Rev.0 – Preliminary • 2015-09-02 28 of 68
Reproduction forbidden without Telit Communications PLC written authorization – All Rights Reserved
A flow chart showing the AT commands managing procedure is displayed below:
NOTE:
In order to avoid a back powering effect it is recommended to avoid having any
HIGH logic level signal applied to the digital pins of the LE866 when the module
is powered off or during an ON/OFF transition.
“Start AT CMD”
START
Delay = 300 msec
Enter AT <CR>
Disconnect PWR Supply
AT answer in
1 sec ?
GO TO
“Modem ON Proc.”
“Start AT CMD”
END
Y
N