User's Manual

xE70-915 RF Module User Guide
1VV0301106 rev.3 – 2015-03-04
Reproduction forbidden without written authorization from Telit Communications S.p.A. - All Rights
Reserved. Page 20 of 34
4.4. DIP – Module Pin-out Correspondence Table
Pin-Out correspondence between xE70-915/DIP and xE70-915/SMD
xE70-915/DIP xE70-915/SMD
Comments
Connector
Pin Name Pin Name
J1
1
2 GND GND
3 P1 J5 IO5_A
4 P2 J9 Status TX/RX Reserved Pin
5 P3 J2 RX LED
6 P4 J1 TX LED
7 P5 J4 IO4_A
8 P6 J3 IO3_A
9 GND GND
10 VDD J25 VDD
J2
11 PROG J16 PROG
12 RTS J22 RTS
13 CTS J24 CTS
14 RESET J23 RESET
15 RxD J21 RxD
16 TxD J19 TxD
17 STDBY J18 STAND_BY
18 RTS J22 RTS
19 P7 J6 IO6_A
20 GND GND
J4
1 J14 PDI_DATA
flashing
2 J10 PDI_CLK
3 J23 RESET
4 J25 VDD
5 GND
J7 IO7_A
Reserved Pin
J8 IO8_AD_DA
J3 SMA connector J29
Ext_Antenna
(Unbalanced RF)
A 50 Ohm coplanar wave guide
and a 0 ohm resistor are used to
connect J29 to J3