User Manual

 wait for OK response
The HE910V2 family is able to identify the caller number and give indication of it before the
call is answered. The calling number is presented after each RING or +CRING indication in
the format:
+CLIP: "<number>",<type>[,"<subaddress>",<satype>[,"<alpha>"[,<CLI validity>]]]
OK
where:
<Number> is the phone number;
<type> is the type of number:
145 - international numbering scheme
129 - national numbering scheme
<subaddress> is the subaddress of the calling party
<satype> is the type of subaddress
<alpha> is an optional string type alphanumeric representation of <number> corresponding
to the entry found in phonebook;
<CLI validity> is the validity status of CLI presentation:
0 CLI valid.
1 CLI has been withheld by the originator.
2 CLI is not available due to interworking problems or limitation or originating network.
In order to use this feature you must enable the caller ID indication presentation, if feature is
disabled then no CLI indication is given after the RING or +CRING code.
 send command AT+CLIP=<n><cr>
where:
<n> is the operation mode selected:
0 - Calling Line Indication Presentation Disabled
1 - Calling Line Indication Presentation Enabled
 wait for OK response
For example:
1- Let us assume you receive a call from the national number 1234567890 and extended
incoming calls indication is disabled while CLIP is enabled, you can see:
ring indication: