User Manual

Example:

Let’s suppose to perform a cold start of the GPS receiver.

AT$GPSR=1<cr>

The Receiver will clear all the parameters in its memory and it will start a new scanning of the

available satellites.

This command allows saving the set parameters in the module’s memory

Syntax of the command

AT$GPSSAV

After this command restart the module to update the modifications.

This command allows restoring the factory default parameters for the GPS module

Syntax of the command:

AT$GPSRST

After this command restart the module to update the modifications.

This command allows reading the acquired position of the GPS receiver

Syntax of the command

AT$GPSACP

The response syntax is:

$GPSACP:<UTC>,<latitude>,<longitude>,<hdop>,<altitude>,<fix>,<cog>,

The fields contain the following information:

<UTC>: (referred to GGA sentence)

hhmmss UTC of Position

Values:

hh (hour) 00 to 23

mm (minutes) 00 to 59

ss (seconds) 00 to 59

<latitude>: (referred to GGA sentence)