User's Manual

HE910 Hardware User Guide

1vv0300925 Rev.28 – 2015-06-24

L'émetteur ne doit pas être colocalisé ni fonctionner conjointement avec à autre antenne ou autre émetteur.

FCC Class B digital device notice

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

Labelling Requirements for the Host device

The host device shall be properly labelled to identify the modules within the host device. The certification label

of the module shall be clearly visible at all times when installed in the host device, otherwise the host device

must be labelled to display the FCC ID and IC of the module, preceded by the words "Contains transmitter

module", or the word "Contains", or similar wording expressing the same meaning, as follows:

HE910, HE910-D

Contains FCC ID: RI7HE910

Contains IC: 5131A-HE910

HE910-GL

Contains FCC ID: RI7HE910GL

Contains IC: 5131A-HE910GL

HE910-NAR, HE910-NAD, HE910-NAG

Contains FCC ID: RI7HE910NA

Contains IC: 5131A-HE910NA

L'appareil hôte doit être étiqueté comme il faut pour permettre l'identification des modules qui s'y trouvent.

L'étiquette de certification du module donné doit être posée sur l'appareil hôte à un endroit bien en vue en tout

temps. En l'absence d'étiquette, l'appareil hôte doit porter une étiquette donnant le FCC ID et le IC du module,

précédé des mots « Contient un module d'émission », du mot « Contient » ou d'une formulation similaire

exprimant le même sens, comme suit :

HE910, HE910-D