User's Manual

HE910 Hardware User Guide
1vv0300925 Rev.28 – 2015-06-24
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 26 of 26
1- Let's assume you need to drive the ON_OFF* pad with a totem pole output of a +3/5 V
microcontroller (uP_OUT1):
2- Let's assume you need to drive the ON_OFF* pad directly with an ON/OFF button:
WARNING
It is recommended to set the ON_OFF* line LOW to power on the module only after VBATT is higher
than 3.22V.