User's Manual

HE910 Hardware User Guide

1vv0300925 Rev.9 – 07-02-2012

This transmission line shall fulfil the following requirements:

ANTENNA LINE ON PCB REQUIREMENTS

Characteristic Impedance

50 ohm

Max Attenuation

0,3 dB

Coupling with other signals shall be avoided

Cold End (Ground Plane) of antenna shall be equipotential to

the HE910 ground pins

Furthermore if the device is developed for the US market and/or Canada market, it

shall comply with the FCC and/or IC approval requirements:

This device is to be used only for mobile and fixed application. In order to re-use the

Telit FCC/IC approvals the antenna(s) used for this transmitter must be installed to

provide a separation distance of at least 20 cm from all persons and must not be co-

located or operating in conjunction with any other antenna or transmitter. If antenna is

installed with a separation distance of less than 20 cm from all persons or is co-located

or operating in conjunction with any other antenna or transmitter then additional

FCC/IC testing may be required. End-Users must be provided with transmitter

operation conditions for satisfying RF exposure compliance.

Antennas used for this OEM module must not exceed the following gains for mobile and

fixed operating configurations:

GSM 850/FDD V: 5.22 dBi

PCS 1900/FDD II: 3.31 dBi

FDD IV: 6.45 dBi

NOTE1:

The HE910-GA is not supporting the FDD BAND IV