User Manual

HE863 Family Hardware User Guide
1vv0300891 Rev.6
- 2011-04-14
Reproduction forbidden without Telit Communications S.p.A’s. written authorization - All Rights
Reserved. Page 89 of 92
The user must refer to below information to meet the FCC/IC's RF
exposure rules and regulations when they design:
• The system antenna(s) used for this transmitter must be
installed to provide a separation distance of at least 20 cm
from all the persons and must not be co-located or operating
in conjunction with any other antenna or transmitter.
• The system antenna(s) used for this module must not exceed
4dBi for mobile and fixed or mobile operating configurations.
• Users and installers must be provided with antenna
installation instructions and transmitter operating conditions
for satisfying RF exposure compliance.
Manufacturers of mobile, fixed or portable devices
incorporating this module are advised to clarify any
regulatory questions and to have their complete product tested
and approved for FCC compliance.
• HE863 Family is intended for the OEM integrator only.
• The user is required to see the Grant of Equipment document
for other restrictions.
• HE863 Family must be operated and used with a locally approved
access point.
• The radio transmitter(IC ID:5131A-HE863NA & IC ID: 5131A-
HE863NAG) has been approved by Industry Canada to operate with
the antenna type listed in this manual with the maximum
permissible gain and required antenna impedance for each
antenna type indicated. Antenna types not included in this
list, having a gain greater than the maximum gain indicated
for that type, are strictly prohibited for use with this
device.