User's Manual

Page 89 of 187
TECHNICAL MANUAL
Telit GM862 PCS
Tri Band GPRS Data Terminal System Rev.1
+CCFC – call forwarding number and condition
Read command
AT+CCFC =
<reason>,2,[number>[,
<type>[,dopo
<time>s]]]
Queries the network for forwarding service settings on a specific
reason. The result is in the form:
+CCFC:<status>,<class>[,<number>[,<type>[,dopo <time>s]]]
where:
<status> = 0 - service not active
<status> = 1 - service active (calls will be forwarded)
<time>: - 1...30 when "no reply" option for reason is enabled or
queried, this gives the time in seconds to wait before call is forwarded,
default value is 20.
The other parameters are as seen before.
Note: When querying the status of a network service (<cmd>=2) the
response line for 'not active' case (<status>=0) should be returned only if
service is not active for any <class>.
Write command
Test command
AT+CCFC=? Reports supported values for the parameter <reason>.
Example
Reference GSM 07.07
SW release Version A