User's Manual

Page 77 of 187
TECHNICAL MANUAL
Telit GM862 PCS
Tri Band GPRS Data Terminal System Rev.1
2.5.2.3 +CR - service reporting control
+CR – service reporting control
Execute command
Read command
AT+CR? Returns current intermediate report setting
Write command
AT+CR = <mode> Controls whether or not intermediate result code +CR: <serv> is returned
from the TA to the TE. If enabled, the intermediate result code is
transmitted at the point during connect negotiation at which the TA has
determined which speed and quality of service will be used, before any
error control or data compression reports are transmitted, and before the
intermediate result code CONNECT is transmitted.
Parameter: <mode>
<mode> = 0 - disables intermediate result code report
<mode> = 1 - enables intermediate result code report
This command replaces V.25ter [14] command Modulation Reporting
Control +MR, which is not appropriate for use with a GSM terminal.
The result code parameter <serv> has the meaning:
ASYNC - asynchronous transparent
SYNC - synchronous transparent
REL ASYNC - asynchronous non-transparent
REL SYNC - synchronous non-transparent.
Test command
AT+CR=? Returns the supported range of values of the parameter <mode>.
Example
Reference GSM 07.07
SW release Version A