User's Manual

Page 66 of 187
TECHNICAL MANUAL
Telit GM862 PCS
Tri Band GPRS Data Terminal System Rev.1
2.4.7 S parameters
2.4.7.1 S0 - number of rings to auto answer
S0 – number of rings to auto answer
Execute command
Read command
ATS0? Returns the current value of S0 parameter.
Write command
ATS0 = <n> Sets the number of rings required before device automatically
answers an incoming call.
Parameter:
<n> = 0-255
<n> = 0 auto answer disabled
Test command
Example
Reference V25ter
SW release Version A
2.4.7.2 S1 - ring counter
S1 – ring counter
Execute command
Read command
ATS1? S1 is incremented each time the device detects the ring signal of
an incoming call. S1is cleared if no ring occur over an eight
seconds interval.
This command returns the value of this parameter.
Write command
Test command
Example
Reference
SW release Version A