User's Manual

Page 60 of 187
TECHNICAL MANUAL
Telit GM862 PCS
Tri Band GPRS Data Terminal System Rev.1
2.4.3.5 A/ - Last command automatic repetition
A/ – last command automatic repetition
Execute command
A/ It is used to execute again the last received command.
This command works only at fixed IPR.
Note: This command has been substituted with AT#/ command.
Refer to #/ command reference.
Read command
Write command
Test command
Example
Reference
SW release Version A
2.4.3.6 H - disconnect
H - disconnect
Execute command
ATH It is used to close the current conversation (voice, data or fax).
Note: When a data conversation is active the device is in on-line mode
commands are not sensed, instead characters are sent to the other
interlocutor. To issue this command you must be in command mode
operation, hence escape sequence (see register S2) may be required before
issuing this command, otherwise if &D1 option is active, DTR pin should be
tied low to return in the command mode.
When a voice call is active, no escape sequence is needed.
Read command
Write command
Test command
Example
Reference V25ter.
SW release Version A