User's Manual

Table Of Contents

Page 49 of 187

TECHNICAL MANUAL

Telit GM862 PCS

Tri Band GPRS Data Terminal System Rev.1

2.4.2.3 V- result code form

V – result code form

Execute command

Read command

Write command

ATV <n> Sets the result code format.

Parameter:

<n> = 0 set the short format (terse) return codes are numbers 0-9.

<n> = 1 set the long form (verbose) return codes.

Note: Line feed is not issued before a short format result code.

Test command

Example

Reference V25ter

SW release Version A

2.4.2.4 X - extended result codes

X – extended result codes

Execute command

Read command

Write command

ATX <n>

Selects the result code messages subset used by the modem to inform the

DTE of the result of the commands.

Parameter:

<n> = 0 - send only OK, CONNECT, RING, NO CARRIER, ERROR, NO

ANSWER results. Busy tones reporting is disabled.

<n> = 1,2,3,4 - reports all messages (default).

Test command

Note For complete control on CONNECT response message see also +DR

command.

Reference V25ter

SW release Version A