User's Manual

Page 48 of 187
TECHNICAL MANUAL
Telit GM862 PCS
Tri Band GPRS Data Terminal System Rev.1
2.4.2 DTE - modem interface control
2.4.2.1 E - command echo
E – command echo
Execute command
Read command
Write command
ATE <n> Controls the command echo response of the device, enabling or disabling the
echo.
Parameter:
<n> = 0 - disables command echo, hence after this command the only
characters received by DTE are the responses to commands sent to device.
<n> = 1 - enables command echo (default) , hence command sent to the
device are echoed back to the DTE before the response is given.
Test command
Example
Reference V25ter
SW release Version A
2.4.2.2 Q - quiet resut codes
Q – quiet result codes
Execute command
Read command
Write command
ATQ <n> Enables or disables the result codes.
Parameter:
<n> = 0 - enables result codes
<n> = 1 - disables result codes
Note: After disabling result codes with ATQ1, the device does not return a
response to commands (usually OK), but command are executed anyway.
Test command
Example
Reference V25ter
SW release Version A