User's Manual

Page 185 of 187
TECHNICAL MANUAL
Telit GM862 PCS
Tri Band GPRS Data Terminal System Rev.1
3 Conformity Assessment
The Telit GM862-PCS module is assessed to be conform to the R&TTE Directive as stand-alone
product, so if you use them it will not be required any further test effort on the modules.
The Telit GM862-PCS module is conform with the following European Union Directives:
¨ R&TTE Directive 1999/5/EC (Radio Equipment & Telecommunications Terminal Equipments)
¨ Low Voltage Directive 73/23/EEC and product safety
¨ Directive 89/336/EEC for conformity for EMC
In order to satisfy the essential requisite of the R&TTE 99/5/EC directive, the GM862PCS module is
compliant with the following standards:
• GSM (Radio Spectrum). Standard: EN 301 511 and 3GPP 51.010-1
• EMC (Electromagnetic Compatibility). Standards: EN 301 489-1 and EN 301 489-7
In this document and the Hardware User Guide, Software User Guide all the information you may
need for developing a product meeting the R&TTE Directive is included.
Furthermore the Telit GM862-PCS module is FCC Approved as module to be installed
in other devices. This device is to be used only for fixed and mobile applications. If
the final product after integration is intended for portable use, a new application and
FCC is required.
The Telit GM862-PCS module is conform with the following US Directives:
¨ Use of RF Spectrum. Standards: FCC 47 Part 24 (GSM 1900)
¨ EMC (Electromagnetic Compatibility). Standards: FCC47 Part 15
To meet the FCC's RF exposure rules and regulations:
- The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20
cm from all the persons and must not be co-located or operating in conjunction with any other antenna
or transmitter.
- The antenna(s) used for this module must not exceed 7 dBi for mobile and fixed or mobile operating
configurations.
- Users and installers must be provided with antenna installation instructions and transmitter operating
conditions for satisfying RF exposure compliance.
Manufacturers of mobile, fixed or portable devices incorporating this module are advised to clarify any
regulatory questions and to have their complete product tested and approved for FCC compliance.