User's Manual
Table Of Contents
Page 182 of 187
TECHNICAL MANUAL
Telit GM862 PCS
Tri Band GPRS Data Terminal System Rev.1
2.10.1.3 #TPHOTO – Camera Take Photo
#TPHOTO – Camera Take Photo Command
Execute command
AT#TPHOTO
Commands the CAMERA to take the photo and stores it in the GM862
memory.
Read command
Write command
Test command
NOTE The photo is kept in the GM862-PCS RAM memory, therefore after a
power off it is lost.
There's only 1 position for the photo, every photo will overwrite the
previous.
The photo is taken during IDLE time, if the mobile is busy on network
operations, (e.g. during a call) the photo cannot be taken.
Example AT#TPHOTO
OK
… the camera has taken the photo and it is now stored on the GM862
memory.
Reference Telit specifications
SW release Version D
2.10.1.4 #RPHOTO – Camera Read Photo
#RPHOTO – Camera Read Photo Command
Execute command
AT#RPHOTO
After this command the GM862 starts to flush the photo in its memory
to the serial line, ending it with the Ok code..
Read command
Write command
Test command
NOTE The photo is flushed as hexadecimal characters in the format selected.
Example AT#RPHOTO
xxxxxxxxxxxx (binary digits of the JPEG image)
<cr><lf>OK<cr><lf>
… the photo has been flushed to the serial line.
Reference Telit specifications
SW release Version D