User's Manual

Page 175 of 187
TECHNICAL MANUAL
Telit GM862 PCS
Tri Band GPRS Data Terminal System Rev.1
2.9.4.4 #DSTO – Data Sending Timeout control
#DSTO –Data Sending Timeout control
Execute command
Read command
AT#DSTO? Reports the current value of the parameter <time>.
Write command
AT#DSTO=<time> This timeout applies when the data to be sent is less that one full packet
size and whose sending would have been delayed for a undefined time
until new data to be sent is received and the full packet size is reached.
This command sets the maximum time that the module awaits before
sending anyway a packet whose size is less than the default one.
Parameter:
<time> - packet sending timeout in 100ms units
0 - no timeout, wait forever for packets to be completed before send.
1…255 hundreds of ms
Test command
AT#DSTO=? Returns the allowed values for the parameter <time>.
Example AT#DSTO = 10 ( 1 sec. Timeout )
OK
AT#DSTO?
#DSTO: 10
OK
NOTE In order to avoid possible low performances issues, it is suggested to
set the <time> parameter to a value greater than 5
Reference Telit specifications
SW release Version C