User's Manual

Page 157 of 187
TECHNICAL MANUAL
Telit GM862 PCS
Tri Band GPRS Data Terminal System Rev.1
2.7.1.14 #ACAL – Set Automatic Call
#ACAL – set automatic call
Execute command
Read command
AT#ACAL?
Returns the current status in the format:
#ACAL: <mode>
Write command
AT#ACAL = <mode> Enable the automatic call.
Parameter:
<mode> = 0 – disable
<mode> = 1 – enable
If enabled, the transition OFF/ON of DTR causes an automatic data
call to the number stored in position number 1 of the phone book.
The &D command must be set to 2.
Test command
AT#ACAL=? Returns the supported range of values of the parameter <mode>.
Example
Reference Telit GM862-PCS AT Command Specification
SW release Future SW Version