User's Manual

Page 155 of 187
TECHNICAL MANUAL
Telit GM862 PCS
Tri Band GPRS Data Terminal System Rev.1
2.7.1.12 #MONI – Monitor Cells
#MONI – monitor cell
Execute command
AT#MONI
Reports the available data for cell and dedicated channel (if exists) in
the format:
#MONI: <netname> BSIC:<bsic> RxQual:<qual> LAC:<lac>
Id:<id> ARFCN:<arfcn> PWR:<dBm> dBm
or in the case the network name is not known:
#MONI: Cc:<cc> Nc:<nc> BSIC:<bsic> RxQual:<qual> LAC:<lac>
Id:<id> ARFCN:<arfcn> PWR:<dBm> dBm
or in the case in which the data of the adjacent cell are under
observation (number>0):
#MONI: Adj Cell<n> [LAC:<lac> Id:<id>] ARFCN:<arfcn>
PWR:<dBm> dBm
where:
netname = name of network operator
cc = country code
nc = network operator code
n = progressive number of adjacent cell
bsic = base station identification code
qual = quality of reception (0-7)
lac = localization area code
id = cell identifier
arfcn = assigned radio channel
dBm = received signal strength in dBm
Read command
Write command
AT#MONI =<number> Set the neighbor cell to extract data of the cell number <number>
Parameter: <number>
Test command
AT#MONI=?
(Version B)
Reports the available neighbour cells and current cell preset in the
format: #MONI: <CellNo, CellSet>
where:
<CellNo> - neighbour cells number
<CellSet> - cell preset = 0, …, n where 0 is the serving cell
Example
Note The refresh time of the measures is preset to 3 sec
Reference Telit GM862-PCS AT Command Specification
SW release Version A