User's Manual

Page 150 of 187
TECHNICAL MANUAL
Telit GM862 PCS
Tri Band GPRS Data Terminal System Rev.1
2.7.1.8 #QTEMP –Query Temperature overflow
#QTEMP – query temperature overflow
Execute command
Read command
AT#QTEMP?
Queries the internal temperature sensor of the device for over
temperature. The result is reported in the format:
#QTEMP:<temp>
where
<temp> - over temperature indicator
<temp> = 0 - device temperature is in the working range
<temp> = 1- device temperature is out of the working range, may be
too high or too low.
Note: The device should not be operated out of its working temperature
range; if temperature is out of range proper functioning of the device is
not ensured.
Write command
AT#QTEMP = <mode> Sets the type of indication.
Parameter:
<mode> - type of indication
0 - result reported only when querying with #QTEMP?
1 - reserved for future use
2 – reserved for future use
Test command
#QTEMP=? Reports supported range of values for <mode> parameter.
Example
Reference Telit GM862-PCS AT Command Specification
SW release Version A