User's Manual

Page 149 of 187
TECHNICAL MANUAL
Telit GM862 PCS
Tri Band GPRS Data Terminal System Rev.1
2.7.1.7 #WAKE – Wake from Alarm mode
#WAKE – Wake from Alarm Mode
Execute command
AT#WAKE=0
After the issuing of this command device exits the "Alarm mode" and
enters the normal operating mode. After entering in normal operating
mode an OK response is returned.
With the execution of is command all Alarm activity (for example
alarm tone playing ) is immediately terminated.
If the command is issued during the normal operating mode then the
only action is to stop Alarm activity, if present, and return OK
response.
Read command
AT#WAKE? This command returns the operating mode status of the device in the
format:
#WAKE: <status>
where:
<status> - operating mode
0 - normal operating mode
1 - alarm mode
Note: The "alarm mode" is indicated by hardware pin CTS to the ON
status and DSR to the OFF status, while the "power saving" status is
indicated by a CTS - OFF and DSR - OFF status. The normal
operating status is indicated by DSR - ON.
During the "alarm mode" the device will not make any network scan
and will not register to any network and therefore is not able to dial
or receive any call or SMS, the only commands that can be issued to
the GM862-PCS in this state are the #WAKE and #SHDN, every
other command must not be issued during this state.
Write command
Test command
Example
Reference Telit GM862-PCS AT Command Specification
SW release Version A