User's Manual

Page 144 of 187
TECHNICAL MANUAL
Telit GM862 PCS
Tri Band GPRS Data Terminal System Rev.1
2.7 Custom AT Commands
2.7.1 General configuration
2.7.1.1 #CAP - Change Audio Path
#CAP – change audio path
Execute command
AT#CAP = <n> Switches the active audio path depending on parameter <n>
Parameter:
<n> audio path
0 - audio path follows the Axe input (default at start up):
Axe = low - handsfree enabled
Axe = high - internal path enabled
1 - enables handsfree external mic/ear audio path
2 - enables internal mic/ear audio path
Note: The audio path are mutually exclusive, enabling one disables the
other.
When changing the audio path, the volume level is set at the previously
stored value for that audio path. (see AT+CLVL).
Read command
AT#CAP?
Reports the active audio path in the format: #CAP: <n>.
Write command
Test command
AT#CAP=? Reports the supported values for the parameter <n>.
Example
Reference Telit GM862-PCS AT Command Specification
SW release Version A