User's Manual

Page 133 of 187
TECHNICAL MANUAL
Telit GM862 PCS
Tri Band GPRS Data Terminal System Rev.1
2.6.2 Message configuration
2.6.2.1 +CSCA - service center address
+CSCA –service center address
Execute command
Read command
AT+CSCA?
Reports the current value of the default SCA in the format:
+CSCA: <number>,<type>
Note: if SCA is not present the device reports an error message.
Write command
AT+CSCA=<number>,
<type>
Sets the Service center Address to be used for mobile originated SMS
transmissions.
Parameter:
<number> - SC phone number in the format defined by <type>
<type> - the type of number
<type> = 145 - international numbering scheme (contains the character
"+")
<type> = 129 - national numbering scheme
Note: to use the SMS service, is mandatory to set a Service Center
Address at which service requests will be directed. SCA depends on
the operator, hence contact your operator to set the right SCA. When
this address is input, it is stored on the SIM if possible, else will be
stored on the device internal memory so, once set, the input of this
parameter is not anymore needed.
In PDU mode, this setting is used, but only when the length of the
SMSC address coded into the <pdu> parameter equals zero; else SCA
defined in the PDU will be used instead.
Test command
Example
Reference GSM 07.05
SW release Version A