User's Manual

Page 100 of 187
TECHNICAL MANUAL
Telit GM862 PCS
Tri Band GPRS Data Terminal System Rev.1
2.5.4.3 +CPIN - enter PIN
+CPIN – enter PIN
Execute command
Read command
AT+CPIN? Reports the PIN/PUK/PUK2 request status of the device in the form:
+CPIN:<code>
where <code> is the PIN/PUK/PUK2 request status code:
READY - device is not pending for any password
SIM PIN - device is waiting SIM PIN to be given
SIM PUK - device is waiting SIM PUK to be given
SIM PIN2 - device is waiting SIM PIN2 to be given; this <code>
is returned only when the last executed command resulted in PIN2
authentication failure (i.e. +CME ERROR: 17)
SIM PUK2 - device is waiting SIM PUK2 to be given; this
<code> is returned only when the last executed command resulted in
PUK2 authentication failure (i.e. +CME ERROR: 18)
PH-NET PIN - device is waiting network personalization
password to be given
PH-NETSUB PIN - device is waiting network subset
personalization password to be given
Note: Pin pending status at startup depends on PIN facility setting, to
change or query the default power up setting use the
AT+CLCK=SC,<mode>, <pin> command.
Write command
AT+CPIN =
<pin>[,<newpin>]
Sends to the device a password (SIM PIN, SIM PUK, PH-SIM PIN,
etc.) which may be required to further operate the device.
If the PIN required is SIM PUK or SIM PUK2, the <newpin> is
required. This second pin, <newpin>,will replace the old pin in the
SIM.
The command may be used to change the SIM PIN by sending it with
both parameters <pin> and <newpin> when if PIN request is pending;
if no PIN request is pending the command will return an error code and
to change the PIN the command +CPWD must be used instead.
Parameters: <pin>, <newpin>
Note: the only commands which are accepted when device is pending
SIM PIN, SIM PUK, or PH-SIM are: +CGMI, +CGMM, +CGMR,
+CGSN, D112; (emergency call), +CPAS, +CPIN.
To check the status of the PIN request use the command AT+CPIN?
Test command