User's Manual

GM862-QUAD / PY Hardware User Guide
1vv0300748 Rev. 1 - 24/10/06
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Right reserved page 15 of 70
2.5.2 Precautions
• The plug should be inserted in the connector only after the installation of the Telit GM862
Family modules in the board. This is to prevent accidental breaking of the antenna
connection during the transport.
• The coaxial cable must be fixed at least in one point, without sliding possibilities.
• The plug insertion/removal must be done axially with the female connector of the GM862,
keeping lateral strains to a minimum.
• The insertion/crimping pull out force must be less than 15N.