User's Manual

TECHNICAL MANUAL
Telit GM862-GPS
Quad Band GPS Data Terminal Module
Pag.51 of 79
Rev. 0
DTE - modem interface control GM862-GPS
E Command echo
•
Q Quiet resut codes
•
V Result code form
•
X Extended result codes
•
I Request identifier and software checksum
•
&C Data carrier detect (DCD) control
•
&D Data terminal ready (DTR) control
•
&K Flow control
•
&Q Sync/async mode
•
&S Data set ready (DSR) control
•
\R Ring (RI) control
•
+IPR Fixed DTE interface rate
•
+IFC DTE - DTA flow control
•
+ILRR DTE - modem rate reporting
•
+ICF DTE - modem character format
•
Call Control GM862-GPS
D Dial
•
T Set tone dial
•
P Set pulse dial
•
A Answer
•
A/ Last command automatic repetition
•
H Disconnect
•
O Return to On Line Mode
•
&G Guard tone
•
Modulation control GM862-GPS
+MS Modulation control
•
%E Enable/disable line quality monitor and auto retrain
or fallback / fallforward
•
\N Operating mode
•
Compression control GM862-GPS
+DS Set data compression
•
+DR Data compression reporting
•
Break control GM862-GPS
\B Transmit break to remote
•
\K Break handling
•
S parameters GM862-GPS
S0 Number of rings to auto answer
•
S1 Ring counter
•
S2 Escape character
•
S3 Carriage return character
•
S4 Line feed character
•
S5 Backspace character
•
S7 Wait time for carrier, silence or dial tone
•
S12 Escape prompt delay
•
S25 Delay to DTR off
•
S30 Disconnect inactivity timer
•
S38 Delay before forced hang up
•
ETSI GSM 07.07 AT Commands GM862-GPS
+CGMI Request manufacturer identification
•
+CGMM Request model identification
•
+CGMR Request revision identification
•