User's Manual

GL865 Hardware User Guide
1vv0300910 Rev.1 – 2011-07-22
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 63 of 79
supported range is from 1 to 8
(see chapter 11)
AT#SIMINCFG?
Read command reports the selected I/O
pin in the format:
#SIMINCFG: 1
AT#SIMINCFG =?
Test command reports supported range
of values for parameters in the
format:
#SIMINCFG : (0 – 8)
0 = disabled
Use the AT command AT#SIMDET=2 to enable the SIMIN detection
Use the AT command AT&W0 and AT&P0 to store the SIMIN detection
in the common profile (See AT Command user guide)
NOTE:
Don’t use the SIM IN function on the same pin where the GPIO
function is enabled and vice versa!