User's Manual

GE910 Hardware User Guide
GE910 Hardware User GuideGE910 Hardware User Guide
GE910 Hardware User Guide
1vv0300962 Rev.9-bis3 2013-05-20
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 85 of 87
Mod. 0805 2011-07 Rev.2
FCC Class B digital device notice
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
Labelling Requirements for the Host device
The host device shall be properly labelled to identify the modules within the host device.
The certification label of the module shall be clearly visible at all times when installed in
the host device, otherwise the host device must be labelled to display the FCC ID and IC
of the module, preceded by the words "Contains transmitter module", or the word
"Contains", or similar wording expressing the same meaning, as follows:
Contains FCC ID: RI7GE910G
Contains IC: 5131A-GE910
L'appareil hôte doit être étiqueté comme il faut pour permettre l'identification des
modules qui s'y trouvent. L'étiquette de certification du module donné doit être posée sur
l'appareil hôte à un endroit bien en vue en tout temps. En l'absence d'étiquette, l'appareil
hôte doit porter une étiquette donnant le FCC ID et le IC du module, précédé des mots «
Contient un module d'émission », du mot « Contient » ou d'une formulation similaire
exprimant le même sens, comme suit :
Contains FCC ID: RI7GE910G
Contient IC: 5131A-GE910
CAN ICES-3 (B) / NMB-3 (B)
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de classe B est conforme à la norme canadienne ICES-003.