User's Manual

GE910 Hardware User Guide
GE910 Hardware User GuideGE910 Hardware User Guide
GE910 Hardware User Guide
1vv0300962 Rev.9-bis3 2013-05-20
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 71 of 87
Mod. 0805 2011-07 Rev.2
13.4. Stencil
Stencil’s apertures layout can be the same of the recommended footprint (1:1), we suggest a
thickness of stencil foil ≥ 120µm.
13.5. PCB pad design
Non solder mask defined (NSMD) type is recommended for the solder pads on the PCB.
13.6. Recommendations for PCB pad dimensions
Units are in mm.
PCB
Copper Pad
Pad
Solder Mask
SMD
(Solder Mask Defined)
NSMD
(Non Solder Mask Defined)