User's Manual

GE910 Hardware User Guide
GE910 Hardware User GuideGE910 Hardware User Guide
GE910 Hardware User Guide
1vv0300962 Rev.9-bis3 2013-05-20
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 70 of 87
Mod. 0805 2011-07 Rev.2
13.3. Recommended foot print for the application
In order to easily rework the GE910 is suggested to consider on the application a 1.5mm Inhibit
area around the module.
It is also suggested, as common rule for an SMT component, to avoid having a mechanical part
of the application in direct contact with the module.
NOTE: In the customer application, the region under INHIBIT WIRING must be clear
from signal or ground paths.