User Guide

GE9
GE9GE9
GE910 Hardware User Guide
10 Hardware User Guide10 Hardware User Guide
10 Hardware User Guide
1vv0300962 Rev.4 2012-06-25
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 8 of 73
Mod. 0805 2011-07 Rev.2
1.4. Document Organization
This document contains the following chapters:
Chapter 1: “Introduction” provides a scope for this document, target audience, contact and
support information, and text conventions.
Chapter 2: “Overview” provides an overview of the document.
Chapter 3: “GE910 Mechanical Dimensions”
Chapter 3: “GE910 Module Connections” deals with the pin out configuration and layout.
Chapter 4: “Hardware Commands” How to operate on the module via hardware.
Chapter 5: “Power supply” Power supply requirements and general design rules.
Chapter 6: “Antenna” The antenna connection and board layout design are the most important
parts in the full product design.
Chapter 7: “Logic Level specifications” Specific values adopted in the implementation of logic
levels for this module.
Chapter 8: “Serial ports” The serial port on the Telit GE910 is the core of the interface between
the module and OEM hardware
Chapter 9: “Audio Section overview” Refers to the audio blocks of the Base Band Chip of the
GE910 Telit Modules.
Chapter 10: “General Purpose I/O” How the general purpose I/O pads can be configured.
Chapter 11: “Mounting the GE910 on the application board” Recommendations and specifics on
how to mount the module on the user’s board.