User Guide

GE9
GE9GE9
GE910 Hardware User Guide
10 Hardware User Guide10 Hardware User Guide
10 Hardware User Guide
1vv0300962 Rev.4 2012-06-25
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 58 of 73
Mod. 0805 2011-07 Rev.2
12.3. Recommended foot print for the application
In order to easily rework the GE910 is suggested to consider on the application a 1.5mm Inhibit
area around the module.
It is also suggested, as common rule for an SMT component, to avoid having a mechanical part
of the application in direct contact with the module.
NOTE: In the customer application, the region under INHIBIT WIRING must be clear
from signal or ground paths.