User Guide

GE9
GE9GE9
GE910 Hardware User Guide
10 Hardware User Guide10 Hardware User Guide
10 Hardware User Guide
1vv0300962 Rev.4 2012-06-25
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 15 of 73
Mod. 0805 2011-07 Rev.2
F15
RESERVED - RESERVED
P11 RESERVED - RESERVED
WARNING:
Reserved pins must not be connected.
NOTE:
If not used, almost all pins should be left disconnected. The only exceptions are the following
pins:
NOTE:
RTS pin should be connected to the GND (on the module side) if flow control is not used.
The above pins are also necessary to debug the application when the module is assembled on it.
PAD signal
M1,M2,N1,N2,P1,P2 VBATT & VBATT_PA
E1,G1,H1,J1,L1,A2,E2,F2,G2,H2,
J2,K2,L2,R2,M3,N3,P3,R3,M4,
N4,P4,R4,N5,P5,R5,N6,P6,R6,P8,
R8,P9,P10,R10,M12,B13,P13,E14
GND
R12 ON/OFF*
R13 HW_SHUTDOWN*
B15 USB_D+
C15 USB_D-
N15 C103/TXD
M15 C104/RXD
L14 C105/RTS
P15 C106/CTS
D15 TXD_AUX
E15 RXD_AUX