User's Manual

GE866-DUAL Hardware User Guide
1VV0301051 Rev. 2 – 2014-04-07 7
Reproduction forbidden without written authorization from Telit Communications S.p.A. - All Rights
Reserved. Page 9 of 82
Mod. 0805 2011-07 Rev.2
1.4. Document Organization
This document contains the following chapters:
Chapter 1: “Introduction” provides a scope for this document,
target audience, contact and support information, and text
conventions.
Chapter 2: “Overview” provides an overview of the document.
Chapter 3: “GE866-QUAD Mechanical Dimensions”
Chapter 4: “GE866-QUAD Module Connections” deals with the pin
out configuration and layout.
Chapter 5: “Hardware Commands” How to operate on the module
via hardware.
Chapter 6: “Power supply” Power supply requirements and
general design rules.
Chapter 7: “Antenna” The antenna connection and board layout
design are the most important parts in the full product
design.
Chapter 8: “Logic Level specifications” Specific values
adopted in the implementation of logic levels for this module.
Chapter 9: “Serial ports” The serial port on the Telit GE866-
QUAD is the core of the interface between the module and OEM
hardware
Chapter 10: “Audio Section overview” Refers to the audio
blocks of the Base Band Chip of the GE866-QUAD Telit Modules.
Chapter 11: “General Purpose I/O” How the general purpose I/O
pads can be configured.
Chapter 12 “DAC and ADC Section” Deals with these two kind of
converters.
Chapter 13: “Mounting the GE866 on your Board” Recommendations
and specifics on how to mount the module on the user’s board.
Chapter 14: “Packing system” Recommendations and specifics on
how the system is packaged.
Chapter 15: “Safety Recommendations” Recommendations and
specifics on how the system is packaged.
Chapter 16: “Document History” Holds all document changes