User's Manual

GE866-DUAL Hardware User Guide
1VV0301051 Rev. 2 – 2014-04-07 7
Reproduction forbidden without written authorization from Telit Communications S.p.A. - All Rights
Reserved. Page 63 of 82
Mod. 0805 2011-07 Rev.2
12.2.2. Using ADC Converter
An AT command is available to use the ADC function.
The command is AT#ADC=1,2
The read value is expressed in mV
Refer to SW User Guide or AT Commands Reference Guide for the
full description of this function.